Updated November 2026

A wood pellet grill tri tip cook comes out juicy and smoky when you run the grill at a moderate temperature, pull the roast at the right internal temperature, and finish with a hot sear. This guide walks through prep, setup, cooking and resting so you can serve sliced tri tip with a pink center and a crusty bark.

What You Need Before You Start

Tri tip is a triangular cut from the bottom sirloin. It has a strong grain that changes direction along the roast, so slicing against the grain matters as much as the cook itself. Most roasts run between 1.5 and 2.5 pounds.

Shopping for one? See our guide: Wood Pellet Grill vs Charcoal (2026): Which Is Better for Your Backyard?.

  • One tri tip roast, 1.5 to 2.5 pounds, with a fat cap about 1/4 inch thick
  • Kosher salt and coarse black pepper, or a simple beef rub
  • Wood pellets suited to beef, such as hickory, oak or a mesquite blend
  • A reliable probe thermometer, ideally a leave-in model with a remote display
  • A sharp slicing knife and a cutting board with a groove to catch juices

Step-by-Step Cooking Method

Step 1: Season and rest the meat

Trim any silver skin but leave the fat cap. Coat the roast with a thin layer of oil, then season generously with salt and pepper. Let it sit uncovered in the fridge for 4 to 12 hours so the salt can work into the meat. Pull it out about 45 minutes before cooking to take the chill off.

Step 2: Preheat the grill to 225 degrees F

Set your pellet grill to 225 degrees F and let it come fully up to temperature with the lid closed. Pellet grills can drift 10 to 20 degrees, so check the grate temperature with a separate thermometer if your grill’s display seems off.

Step 3: Smoke to 120 to 125 degrees F

Place the roast fat side up, directly on the grate, and insert the probe into the thickest part without touching bone or the grate. Smoke until the internal temperature reaches 120 to 125 degrees F. For a 2-pound roast this usually takes around 90 minutes to 2 hours, but use temperature rather than the clock.

Step 4: Sear over high heat

Raise the grill to 450 to 500 degrees F, or open the firebox and sear over direct flame if your model allows it. Sear each side for 2 to 4 minutes until a dark crust forms. Aim for a final internal temperature of about 130 to 135 degrees F for medium rare, or 140 degrees for medium.

Step 5: Rest and slice

Move the roast to a board, tent loosely with foil, and rest for 10 to 15 minutes. Find the grain direction, which usually changes near the middle of the roast, and slice across it in thin pieces.

Quick Reference Table

Stage Grill temperature Target internal temp
Smoke 225 degrees F 120 to 125 degrees F
Sear 450 to 500 degrees F 130 to 135 degrees F (medium rare)
Rest Off heat, tented Carryover rises 3 to 5 degrees

Common Mistakes to Avoid

  • Slicing with the grain. Check the direction before cutting, because the grain changes across the roast.
  • Pulling by time alone. Pellet grills and roast thickness vary, so rely on a probe.
  • Skipping the rest. Cutting straight off the grill lets juices run out.
  • Oversmoking. Beef takes smoke quickly, so a strong wood can turn bitter. Stick to mild hardwoods.
  • Searing too early. A cold, undercooked center with a hot sear leaves the roast unevenly done.

A leave-in probe thermometer with a remote display lets you watch the internal temperature without lifting the lid. View on Amazon

A long, thin slicing knife makes clean cuts across the grain on a tri tip. View on Amazon

A grooved cutting board catches juices during resting so they can be poured back over the slices. View on Amazon

FAQ

What temperature should a wood pellet grill tri tip reach?

Pull the roast at 120 to 125 degrees F before searing, then finish around 130 to 135 degrees F for medium rare. Carryover heat will raise the temperature a few degrees while it rests.

Can I cook tri tip on a pellet grill without searing?

You can, but the crust will be pale and soft. A short high-heat sear adds color and texture that most people expect from tri tip.

How long should I smoke a tri tip?

Most 2-pound roasts take roughly 90 minutes to 2 hours at 225 degrees F, but internal temperature is the reliable guide. Check the probe rather than the clock.

Conclusion

A wood pellet grill tri tip is forgiving once you control three things: a low smoke, a probe-based pull temperature, and a short high-heat sear. Rest the meat, slice against the grain, and you will get tender, smoky slices every time. For food safety guidance on beef doneness, check current USDA recommendations.

Miles Sinclair

About Miles Sinclair

Miles Sinclair is part of our editorial team and reviews and edits our BBQ & grilling guides, checking product details against manufacturer specifications and owner feedback.