Updated November 2026
Pork tenderloin on smoker cooks are one of the quickest ways to get smoky, tender pork without a full overnight burn. You will learn how to prep the meat, set your smoker to a steady low temperature, pull the tenderloin at the right internal temperature, and rest it so the juices stay put. The whole cook usually takes about 1 to 2 hours, depending on the size of the roast and how hot your smoker runs.
Prep the Tenderloin Before It Hits the Smoker
Start by removing the silver skin, the thin, chewy membrane on the outside of the meat, since it will not break down with smoke. Pat the tenderloin dry, then coat it with a thin layer of yellow mustard or olive oil so the rub sticks. Season generously with a pork rub, and let the meat sit at room temperature for 20 to 30 minutes while the smoker comes up to heat. If you want a ready-made flavor base, a 5 Best BBQ Pork Tenderloin Dry Rubs for Juicy Results (2026) is a good place to start.
Shopping for one? See our guide: 7 Best Pork Shoulder Pellet Smoker Picks for Pulled Pork (2026).
Set Up the Smoker and Control the Heat
Run your smoker at 225°F to 250°F. That range gives you enough smoke flavor without drying out the lean meat. Use a mild wood such as apple, cherry or pecan; heavy woods like hickory can overwhelm a cut this small. If you are new to smoker temperature control, How to Smoke Pork Tenderloin in a Smoker: A Step-by-Step Guide walks through the same setup with more detail on airflow and wood timing.
Cook to the Right Internal Temperature
Insert a leave-in or instant-read thermometer into the thickest part of the tenderloin, away from the bone-free ends. Pull the meat when it reaches 140°F to 145°F. Pork is safe at 145°F with a three-minute rest, and it stays juicier than well-done pork. Expect the cook to take roughly 1 to 1.5 hours for a 1- to 1.5-pound tenderloin at 240°F, though thickness and wind will change that.
- Trim the silver skin and pat the meat dry.
- Apply a binder and rub, then rest for 20 to 30 minutes.
- Preheat the smoker to 225°F to 250°F with mild wood.
- Smoke until the thickest part reads 140°F to 145°F.
- Rest for 10 minutes, then slice across the grain.
Finish, Rest and Slice for Maximum Tenderness
If you want a bit of crust and color, sear the tenderloin over high direct heat for 60 to 90 seconds per side after the smoke, or raise the smoker to 350°F for the last 10 minutes. Tent the meat loosely with foil and rest it for 10 minutes so the juices redistribute. Slice into medallions about three-quarters of an inch thick, cutting across the grain to keep each bite tender.
Common Mistakes
- Cooking to a set time instead of an internal temperature, which leads to dry pork.
- Skipping the silver skin removal, which makes the finished slices chewy.
- Using heavy hickory or mesquite wood for too long on a small cut.
- Slicing before the 10-minute rest, which lets the juices run out onto the board.
- Running the smoker too hot, which can cook the outside before the center reaches temperature.
Recommended Gear
- Instant-read digital thermometer: Gives a fast, accurate reading in the thickest part of the tenderloin so you can pull it at the right moment. View on Amazon
- Leave-in probe thermometer: Lets you monitor the meat without opening the smoker lid, which keeps the heat steady. View on Amazon
- Mild smoking wood pellets or chunks: Apple and cherry add a light, sweet smoke that suits pork tenderloin well. View on Amazon
FAQ
What temperature should pork tenderloin reach in a smoker?
Pull the tenderloin when the thickest part reads 140°F to 145°F, then rest it for about 10 minutes. The carryover heat will bring it to a safe, juicy finish.
How long does pork tenderloin take to smoke?
Most tenderloins take about 1 to 1.5 hours at 225°F to 250°F. Thickness, starting temperature and outside weather all affect the total time, so rely on the thermometer rather than the clock.
Should I wrap pork tenderloin in foil while smoking?
Wrapping is not necessary for a tenderloin because the cook is short and the meat is lean. Keep it unwrapped to build a light bark, and tent with foil only during the rest.
Conclusion
Smoking pork tenderloin comes down to three things: clean prep, steady low heat, and pulling the meat at 140°F to 145°F. Follow those steps and you will get tender, smoky slices with a juicy center. Use a reliable thermometer and let the meat rest before slicing, and your pork tenderloin on smoker cooks will be consistent every time.

