Updated November 2026
Smoked steak on pellet grill cooking gives you a tender, evenly pink interior with a deep smoky flavor that a hot grill alone can’t match. The method is simple: cook the steak low and slow until it approaches your target internal temperature, then finish with a hot sear for a crust. This guide walks through the setup, cooking steps and common errors so your steaks come out right the first time.
Choose the Right Cut and Thickness
Thick cuts handle smoke best. Ribeye, strip, sirloin and tri-tip all work well, and a steak around 1.5 to 2 inches thick gives the smoke time to season the meat without overcooking the center. Thin steaks under an inch tend to dry out before they pick up much smoke, so save those for a fast sear.
Pat the steak dry and season it at least 45 minutes ahead, or salt it the night before. A basic mix of coarse salt and black pepper is enough, and you can add a steak rub if you prefer a more layered flavor. For more seasoning ideas, see 7 Best Steaks on a Pellet Grill Accessories and Rubs for Perfect Results (listed as 7 Best Steaks on a Pellet Grill Accessories and Rubs for Perfect Results).
Set the Grill and Smoke the Steak
Preheat the pellet grill to 225°F with a mild wood such as oak, hickory or cherry. Let it stabilize for about 15 minutes before adding the steak. Place the steak on the grate away from the firebox, and insert a probe into the thickest part without touching bone or fat.
- Preheat the grill to 225°F and let the temperature settle.
- Place the seasoned steak directly on the grate.
- Smoke until the internal temperature is about 10 to 15 degrees below your target. For medium-rare, pull at around 120°F; for medium, around 130°F.
- Rest the steak on a board while you raise the grill temperature.
Expect a 1.5-inch steak to take roughly 60 to 90 minutes at 225°F, though thickness, starting temperature and wind all shift the timing. Trust the probe, not the clock. For a broader look at temperature control, see Pit Boss Pellet Grill Temperature Probe: Accurate Readings Guide (Pit Boss Pellet Grill Temperature Probe: Accurate Readings Guide).
Sear for a Crust
Smoking alone leaves the surface soft and gray, so finish with a sear. Raise the pellet grill to 500°F or higher, or move the steak to a hot cast-iron pan or a direct flame if your grill allows it. Sear each side for about 60 to 90 seconds until a dark crust forms.
Let the steak rest for 5 to 10 minutes after searing. This lets the juices redistribute so the first cut doesn’t run across the board. Slice against the grain for the most tender bite.
Tips and Common Mistakes
- Don’t smoke steak too hot. Temperatures above 275°F cook the outside before the smoke can penetrate.
- Skip the thin steaks for long smoking; they dry out fast.
- Don’t rely on color alone. Use a reliable probe and check the center.
- Avoid heavy sugary rubs before smoking, since they can burn during the sear.
- Give the steak a full rest before slicing, or the juices will end up on the plate.
Recommended Gear
- Instant-read meat thermometer: Confirms doneness quickly during the sear and rest stages. View on Amazon
- Cast-iron skillet: Gives you a hot, even surface for searing if your grill can’t reach high heat. View on Amazon
- Cutting board with juice groove: Catches resting juices so you can pour them back over the sliced steak. View on Amazon
FAQ
What internal temperature should smoked steak reach?
For medium-rare, pull the steak around 120°F and let carryover heat bring it to about 125°F. For medium, pull at about 130°F.
Can I smoke steak on a pellet grill without searing it?
You can, but the surface will be soft and gray. A high-heat sear of 60 to 90 seconds per side adds the crust most people expect from a steak.
What wood pellets work best for steak?
Mild woods such as oak, hickory and cherry are popular choices because they add flavor without overpowering the beef.
Conclusion
Smoked steak on pellet grill cooking is easy once you control three things: the thickness of the cut, a low smoking temperature and a hot finishing sear. Pull the steak by internal temperature, rest it properly and slice against the grain. With a little practice, you’ll get steaks that are smoky, tender and evenly cooked from edge to edge.

